Below follows a description of all parameters that can be set by the SET/OPTOPUS command, the commands which use these parameters and the default values. These parameters are stored in keywords and will be use as default values for subsequent OPTOPUS commands. If an OPTOPUS command the default value is not used the command will, in addition to actual OPTOPUS operation, also overwrite the setting of this parameter and hence will change the default value.
SET/OPTOPUS OLDEQ=1950.0 ! set the equinox
CREATE/OPTOPUS mydata mytable ? 2000.0 ! use another equinox
SHOW/OPTOPUS ! equinox value is now 2000.0
Table: Command parameters (cont.)
