next up previous contents
Next: ASTROMET/TRANSFORM Up: ASTROMET astrometry package Previous: Introduction

Available Commands

The context ASTROMET can be enabled by the command SET/CONTEXT ASTROMET. While in the original implementation everything was done in one programme, in the context ASTROMET the software is split into three commands. These commands take care of the following:

Steps 1 and 2 can be iterated until a satisfactory result is obtained.

The whole process can also be executed in an iterative way by the command ASTROMET/POS1. This commands asks for all input parameters.





Rein Warmels
Mon Jan 22 15:08:15 MET 1996