Depending on the further reductions the data may be transformed into
the coordinate system which is most relevant for the physical
interpretation. This will typically be used when certain
characteristics of the data will appear as a linear relation in the
new coordinates. These transformations involve non--linear rebinning
as discussed in Section 
. To conserve flux in the new
system, the pixel values must be corrected by the Jacobian determinant
in Equation .
For spectra a transformation from wavelength to frequency is used to identify spectral regions which follow a power law. This transformation is given by
where 
is the frequency and 
is wavelength.
The intensities I are translated to a logarithmic scale (e.g. magnitudes
) so that a power law spectrum appears linear.
In the classification of galaxies, ellipticals can be distinguished on
their radial surface brightness profile which can be approximated
by 
.
This gives the transformation formula
Since the intensity profile only should be resampled, the flux
correction is not applied in this case. A logarithmic scale is also
used here to achieve a linear relation. An example is given in
Figure .
Whereas the transforms mentioned above only perform a non--linear rebinning of the data, the Fourier transform converts a spatial image into the frequency domain. This transform has two main applications namely analysis of periodic phenomena and convolution due to its special properties. The transform can be given as
where 
are the spatial frequencies and i denotes the imaginary part.
The corresponding inverse transform is then
Special numeric techniques, called Fast Fourier Transforms or FFT, can significantly decrease the time needed to compute these transforms. They are optimized for images with a size equal to a power of 2 (see e.g. Hunt 1969) but can also be used in other cases.
To analysis the periodic occurrence of features in time series,
spectra, or images the amplitude of the Fourier transform or the power
spectrum is used. The power spectrum 
of the function F is
given by
Peaks in 
indicate the presence of specific frequencies while
the continuum originates from a combination of objects and noise.
Since the Fourier transform assumes the image to occur periodically,
discontinuities at the edges of the image will produce artificial
contributions to the power spectrum. Thus, care should be taken to
remove systematic background variations to avoid this happening. As
an example of using Fourier transforms to extract information from a
frame, an azimuthal intensity profile of the spiral galaxy A0526--16
is shown in Figure .
Figure: Azimuthal profile in the inner parts of a spiral galaxy A0526--16
across the spiral arms (A). The amplitude of the Fourier
transform (B) of this profile shows the strong even frequencies.
The radius was chosen so that the profile intersects the spiral
pattern in the inner parts of the galaxy. In the amplitude plot of
the Fourier transform, it can be seen that the spiral pattern mainly
contains even frequency components. The 
and 
harmonic indicates that the wave is asymmetric due to non--linear
effects in the spiral density wave.
It is possible to use the transformation for convolutions because this operation corresponds to a multiplication in the frequency domain :
where 
and 
denote the Fourier transform
and convolution operators, respectively.
Especially when the convolution matrix is large it is more efficient to
perform the operation in frequency than in spatial domain.
